A sump pump is a pump used to remove water from sumps usually found in the basement of the house. It serves to keep the basement and foundations of the house dry to prevent seepage which not only damages the building, but even the repair work may turn out to be very costly. The issue is very common in houses where the water table lies at the foundation of the house or in areas which have heavy rainfall. It also becomes very vital when the snow begins to melt, and there is a chance of flooding. Its primary job is to pull the water out of the pit at the basement of your house and drain it to the garden or any other area away from the house. The various types of best sump pump reviews available at online store first you can check customer reviews and choose the best sump pump for your basement.
A sump pump may sit in your house for an extended period, unused and untouched; but when you need it, you need it immediately. Though it does not require a very high level of care and repair, it is better to keep it in checked and maintained to avoid any hassle later. Here are a few things that need to be taken care of:
1. Check the power cord:
It is safer to check the power supply for the pump when it is not in use. Make sure the power supply is working properly, and the cord is the poor condition. Reset the GFCI and Do check the circuit breaker every once in a while for proper functioning. It would be helpful for safe work with your machine and better for both you and your set up also.
2. Make sure it is properly fixed:
Too much use over a specified period may cause the shaft to tilt or move from its original position. Make sure it is set to its upright position and fix immediately if not. Because whenever a sump pump is not properly attached or has a fault in placement or has a drifting place then it could be dangerous as well as disturbing for the functionality as well as the efficiency of the sump pump. Correct installation and placement are the basics of making a sump pump work at its best.
3. Checking the float valve:
A float valve is the key component of a sump pump. In automatic sump pumps, the float determines when the pump is switched on/off. Every so often, pour water in the pit to make sure that the float starts automatically and shuts off when this water is drawn off. If it does, well and good, and if it does not, get it mended.
4. Lubrication of its parts:
Do check the pump bearings if they require any lubrication and oiling. Your user’s manual will give you adequate information about your particular model.
5. Cleaning the pit:
The soil, mud, and debris from the water are the major cause of clogging and faulty floats. The problem is far greater in areas which have heavy rainfall, and there is the higher probability of floods. The excess amount of trash may significantly affect the efficiency of the pump. So, it needs to be cleaned regularly, especially when the pump is in continuous use. Cleaning the pump would result in increased efficiency through eliminating any debris or scales and also if there is muddy water to be pumped you should be cleaning it regularly.
September 2018 M T W T F S S « Jul 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30